Numeravo

Numeravo

Smart calculators

Steel reference

Nominal Wall, Design Wall, and Manufacturing Tolerances

What you need to know

Nominal wall identifies the ordered section. Design wall is the thickness basis used by the applicable calculation method. Manufacturing tolerance defines permitted product variation under its specified conditions.

Applies to US steel-product terminology and document reading. Verify the specification and edition used for your project.

Match the specification

STI discusses differing HSS specifications and their thickness treatment. Its article references particular historical standards and design editions. Check the editions governing the current project before applying a numerical factor.

Separate the three records

An order can state nominal wall, a calculation can identify a design thickness, and a receiving report can record measured thickness. Preserve the units, method, location, source, and purpose with each record. A single thickness field loses that context.

A document-reading example

A worksheet labeled nominal wall and a calculation labeled design wall may legitimately use different values. First check their definitions and governing documents. Do not replace either value solely to make the worksheets agree.

When clarification is needed

Refer uncertain acceptance measurements to the applicable product standard and inspection plan. Refer calculation thickness choices to the responsible designer. Numerical reduction factors, tolerance limits, and acceptance decisions are outside this introductory page.

Reference checklist

Records to compare before using a value
RecordWhat to verify
Product identificationMaterial specification, grade, shape, size, and units
SourcePublisher, document designation, edition, and table or section
ApplicationOrdering, measurement, calculation, or project acceptance

Questions and answers

Is manufacturing tolerance the same as corrosion allowance?

They describe different purposes. Preserve the separate source and basis for each in project documents.

Can I apply one thickness factor to every HSS specification?

Verify the factor against the exact material and calculation standard editions. This page intentionally supplies no universal factor.

Sources and further reading

Steel Tube Institute reference

August 2022 article, overview table updated February 9, 2024. Public page checked November 17, 2026. Source scope and terminology reviewed. Project-specific engineering and acceptance remain with the responsible professional.

Related references

Report a correction

Email contact@numeravo.com

Include the page title, issue, and an optional source.

Related calculators

Use these tools for the measurement tasks described below. Verify the product designation and project requirements before applying a converted value.